Smart Homes 3-in-1 STEM Launch Pack
Build three small smart-home models: a Rain Sensor that sounds when drops land on its roof, an Object Immobilizer that sounds when something is taken away, and a lamp powered wirelessly by a magnetic field.
At a glance
- Models
- Rain Sensor (A-16), Object Immobilizer (A-17), Wireless Power Transmission (E-11C transmitter + E-11D lamp)
- Power
- AA batteries: 2 for the Rain Sensor, 2 for the Immobilizer, 3 for the transmitter
- You’ll need
- Small screwdriver, Scissors, AA batteries (2 + 2 + 3), A lighter, used by an adult (wireless build)
- What it teaches
- How sensors turn the world into yes-or-no signals, Why water conducts and how infrared reflects, How a changing magnetic field carries energy without wires
- Good to know
- None of the models is programmed: no coding, no AI, no voice control., The 3-pin cable colours vary: match S to S, V to V and G to G.
What you’ll learn
- Sensors and signals. Each sensor answers yes or no: the S wire is high or low, a first look at 1s and 0s.
- Water and electricity. Why rainwater lets current cross between two combs that never touch.
- Infrared light. Light we can’t see, and why white, black and clear objects behave differently.
- Electromagnetic induction. How a changing magnetic field carries energy with no wires, like a phone charger.
Shop the Smart Homes 3-in-1 STEM Launch Pack
Frequently asked questions
- Is any of it programmed?
- No. All three models are circuits that switch on and off by themselves. There is no coding, AI or voice control.
- Does the Rain Sensor need real rain?
- No. Drips of tap water from a dropper work, because tap water conducts too. Keep water off the batteries and boards.
- How close must the object be for the Immobilizer?
- Touching the box, 1 to 2 cm from the window and never more than 3 cm. Black and clear objects can’t be detected.
- How far can the wireless lamp be?
- About 5 cm. It dims as you move it away. Adding more batteries does not make it reach further.
- Why is a lighter needed?
- The wireless build burns the coating off the copper wire ends before sanding them. An adult should do this, before class or at a separate station.
- Do I need to install anything?
- No. The 3D models, the course and the parts page run in a web browser on a smartboard, laptop, tablet or phone.
- Rain Sensor: nothing lights
- Check the batteries are fresh and the right way round, and the battery switch is closed.
- Rain Sensor: water on the plate but no alarm
- Try fresh batteries, set the dial again gently, and check the 3-pin plug letters match.
- Rain Sensor: the alarm sounds with a dry plate
- The dial is turned too far. Set it again with the plate dry.
- Immobilizer: no alarm when the cup is taken away
- Check the batteries, and push the 3-pin cable fully on at both ends.
- Immobilizer: the alarm sounds with the cup there
- The cup must touch the box. Black or clear cups and strong sunlight also stop it working.
- Wireless: no reaction at all
- Switch the battery box on and check every battery’s direction. A backwards battery stops it and may damage the board.
- Wireless: transmitter light on, lamp dark
- Sand the coating fully off the wire ends, and clamp the loop wires tightly in the lamp’s terminal.
- Wireless: the lamp only lights very close
- Point each coil’s tail straight up, use exactly 3 primary turns no higher than 15 mm, and adjust the loop’s height.