Robotic Arm
Press and hold a button and one motor runs: the arm turns, lifts, reaches or grabs. A radio signal, a receiver, four slow-but-strong gear motors, rods and gears do the work.
At a glance
- Build
- 53 photo steps, about 60 minutes.
- Power
- 4 AA batteries in the arm and 2 AA in the remote (not included)
- You’ll need
- Small screwdriver, Small scissors, 6 AA batteries
- What it teaches
- How a radio remote sends a message, How a motor runs both ways, Gears that trade speed for strength, Cranks, rods and levers
- Good to know
- Don't use Nanfu or lithium batteries (manual)., Let go of a button as soon as a joint stops moving., Lift light things only: about 80 g or less.
What you’ll learn
- How a radio remote works. A coded 2.4 GHz signal, paired to one arm.
- How a motor runs both ways. Reverse the current and the motor reverses.
- How gears trade speed for strength. And why you let go at the end of a joint.
- How rods and levers move an arm. And why it lifts less when it reaches far.
Frequently asked questions
- Which batteries should I use?
- Six AA batteries: four in the arm, two in the remote. The manual says not to use Nanfu or lithium batteries. The manufacturer recommends NiMH rechargeables.
- How long do the batteries last?
- The manufacturer says a set lasts a little over 10 minutes of use, because four motors use a lot of power.
- Will 20 remotes in one classroom interfere?
- Not normally: each remote is paired with its own arm. Pair kits one at a time with the others switched off, or a remote can pair with a neighbor's arm.
- How far away does the remote work?
- About 10 to 15 meters in a classroom and 20 to 30 meters in the open, says the manufacturer. Walls, metal and low batteries shorten it.
- How much can it lift?
- Keep it to about 80 g or less. It can manage about 120 g for a moment with the arm pulled in, but only about 50 g stretched out.
- Why does the arm sink when I let go?
- The motors don't lock in place. With something in the claw, a joint can slowly slide down.
- Can I program it?
- No. It's remote control only: one button runs one motor one way while you hold it. There's no coding or position memory.
- Do I need to install anything?
- No. The 3D model and the course run in a web browser on a smartboard, laptop, tablet or phone. The 3D model needs WebGL, which almost every modern browser has turned on.
- Nothing moves at all
- Check the batteries first. Then switch the remote ON and press the arm's rocker switch to ON (step 51).
- Nothing moves and the indicator light flashes slowly
- The remote and arm have lost each other. Fit fresh batteries, move closer, then re-pair them, one kit at a time with the other arms switched off.
- The motor hums but the joint doesn't move
- The most common fault. Check the gears mesh (not too tight) and that the orange rings sit in the grooves at both ends of each shaft. Turn the gears gently by hand before switching on.
- A joint moves the wrong way
- That motor's two wires are reversed. Unplug it, swap the two wires in the plug and plug it back in. Never force a plug in backwards.
- A joint moves only one way
- It may already be at its end. Move it back by hand and check for a broken gear tooth.
- The claw opens but won't hold things
- Adjust the claw gears so they close fully without binding, check the fingers move together, and pick rough objects of 80 g or less.
- The arm stutters or stops mid-use
- The batteries are getting low, or there's 2.4 GHz interference. Fit fresh batteries and move away from the Wi-Fi router.